1999


From: DOE/Lawrence Berkeley National Laboratory

Berkeley lab researchers explain the striking effects of nitrogen in a semiconductor alloy

BERKELEY, CA — The urgent search for more efficient solar cells has recently focused on incorporating small amounts of nitrogen into the semiconductor alloy gallium indium arsenide. Nitrogen atoms have a small ionic radius; usually, the incorporation of smaller atoms into a semiconductor alloy causes the material's band gap to increase. In striking contrast, adding even a little nitrogen to gallium indium arsenide decreases its band gap dramatically, an effect of great significance for the design of advanced solar cells.

This surprising behavior has now been explained by scientists at the Department of Energy's Lawrence Berkeley National Laboratory, working with colleagues at the National Renewable Energy Laboratory (NREL). The researchers found that nitrogen forms a narrow energy band in gallium indium arsenide that splits the alloy's conduction band in two. The subbands push each other apart, and the lower subband reduces the fundamental band gap.

This discovery by the Berkeley Lab-NREL collaboration, which is sponsored by the Photovoltaic Materials Project of the Department of Energy's Center for Excellence in Synthesis and Processing, is of fundamental significance to the understanding of semiconductor alloys and may suggest new approaches to the fabrication of highly efficient solar cells.

"One reason today's solar cells are not very efficient is that no one material can respond to a wide range of frequencies of sunlight," says Wladek Walukiewicz of Berkeley Lab's Materials Sciences Division (MSD). "At NREL they invented a cell made from thin layers of different alloys, with different band gaps sensitive to different photon energies in the solar spectrum."

The band gap is the difference in energy between a semiconductor's valence band, which is filled with electrons, and its conduction band, which is empty. (Bands are not physical locations but energy levels, analogous to the energy levels of electron orbitals around an atomic nucleus.) Since charge cannot flow in a completely full band or a completely empty one, pure semi-conductors are usually insulators at low temperatures. Solar cells, however, are designed so that when photons with enough energy boost electrons out of the valence band into the conduction band, charge can flow in both bands— as negatively charged electrons in the conduction band, or as positively charged "holes" in the valence band.

By depositing thin layers of gallium indium phosphide with a band gap of 1.8 electron volts (eV) on layers of gallium arsenide with a band gap of 1.4 eV, NREL investigators created a tandem solar cell with proven 30-percent efficiency— compared to efficiencies of 10 to 16 percent typical of silicon. While too expensive for routine use, the tandem cell has found a market in solar panels for communications satellites and other spacecraft.

NREL researchers now want to add a third semiconductor layer to the cell, with an even lower band gap responsive to lower energy photons in sunlight. They estimate that a layer with a 1-eV band gap could increase such a cell's efficiency to 40 percent.

"They need a new material with a one-eV band gap and a crystal lattice structure that matches that of gallium arsenide, so the layers can be grown next to each other," says Walukiewicz. "They found that by adding just a little nitrogen to gallium indium arsenide, they could achieve the desired band gap and an almost perfect lattice match."

When nitrogen and other atoms with small ionic radii are added to most semiconductor alloys, the band gap increases. Why should adding just a little nitrogen significantly reduce the bandgap of gallium indium arsenide? Walukiewicz and his MSD colleagues Wei Shan, Joel Ager, and Eugene Haller set out to solve the mystery.

Data from other semiconductors with low concentrations of nitrogen had indicated that nitrogen produces "a localized, narrow band of its own," Walukiewicz says. "Because nitrogen is so different from arsenic and the other elements in these alloys, it doesn't mix — it keeps its own identity." The researchers calculated that in gallium indium arsenide, this nitrogen band should lie a few tenths of an electron volt above the lowest energy of the conduction band.

They predicted that the presence of the nitrogen level would split the conduction band in two. "The nitrogen band is like a knife, it cuts the conduction band in half," Walukiewicz says. Thus, while the band gap to the conduction band's lower part was reduced to 1 eV, "there is also an upper conduction band, and we needed to find it and characterize its behavior to prove our model."

On a substrate of gallium arsenide the researchers grew samples of gallium indium arsenide with varying small concentrations of nitrogen. The samples, only 200 micrometers (millionths of a meter) square and less than five micrometers thick, were examined with modulated beams of light as the samples were squeezed in a diamond anvil cell to many thousands of times atmospheric pressure.

Different colors of modulated light revealed the unmistakable signature of two conduction bands; in agreement with Walukiewicz's model, the conduction bands initially moved closer and then grew farther apart as the pressure was gradually increased. The unequivocal observation of this repulsive "anticrossing," a well-known quantum mechanical effect, confirmed the model.

The model also explains why, despite the small band gap, gallium indium arsenide with nitrogen has so far proved disappointing in solar cells.

"The flat curvature of the lower band is not good news for electron mobility," says Walukiewicz. As charge carriers, the electrons are short-lived and tend to recombine with holes before they have traveled far enough to contribute to the solar cell's output of electric current. "We are now working to see if the split-band structure affects carrier mobility in a basic way, or if there are approaches that might improve the situation."

One approach might be to increase the amount of nitrogen to as much as ten percent of the alloy, through ion-beam implantation — although "atomic nitrogen is hard to get, because nitrogen likes to be a molecule — it's the strongest-bound molecule in the universe."

Another approach might be to substitute different small-ionic-radius atoms, such as boron, for nitrogen. "But boron doesn't like to go into the alloy, and brute force implantation could damage the semiconductor crystal."

It might also be possible to improve the quality of the alloy through novel growth techniques, or through annealing or some other process that might reduce the number of crystal defects which can trap and recombine charges. "After all," says Walukiewicz, "even gallium arsenide was a lousy material with poor properties, in the beginning."

Meanwhile, gallium indium arsenide with nitrogen holds promise for other applications besides solar cells, such as in fiber optics, detectors, and light-emitting diodes. The theoretical and observational studies of its completely new conduction-band structure open a new perspective on the properties, behavior, and possible applications of other "highly mismatched" alloys as well.

Wei Shan, Wladek Walukiewicz, and Joel Ager of Berkeley Lab's MSD, Eugene Haller of MSD and the University of California at Berkeley, and John Geisz, Daniel Friedman, Jerry Olson, and Sarah Kurtz of NREL report their findings in Physical Review Letters, 8 February 1999.

The Berkeley Lab is a U.S. Department of Energy national laboratory located in Berkeley, California. It conducts unclassified scientific research and is managed by the University of California.




This article comes from Science Blog. Copyright � 2004
http://www.scienceblog.com/community